DIY Tin Door Cabinet

Joyful Wednesday guys! We had loads pleasant crashing the Sample Retailer last week. We hope you liked that video! Instantly we’re exhibiting you methods we constructed the DIY Tin Door Cabinet! Strive the video HERE or underneath!

How cute did that find yourself??

Sooner than we get started, be sure to get hold of and print out the FREE PRINTABLE PLANS by clicking HERE!

The first step is setting up the sector of the cabinet. This makes use of three/4” hardwood plywood. We now have the ironmongery retailer rip it for us ,and we make the smaller cross cuts at home. Use a Kreg Jig to make 3/4” pocket holes on the underside and side gadgets. Join the underside piece to the side gadgets using 1.25”pocket hole screws and wood glue. Line the board up 2.75” from the underside of the boards like confirmed. We used our Kreg Jig K5 for to create our pocket holes. That’s our fav Kreg Jig model!

Subsequent, cut back and repair the boards for the face physique..Join the side boards to the underside base board and excessive board using wood glue and 1.25” pocket hole screws through the three/4” pocket holes. Discover the place these must line up!

Subsequent join the face physique to the doorway of the cabinet using wood glue and 1.25” brad nails. The underside board will overhang on both facet by 3/4”.

Join the side base boards with wood glue and 1.25” brad nails.

Join the divider to the center of the underside using wood glue and 1.25” pocket hole screws. Join the doorway and excessive of the center divider to the once more of the doorway face physique using wood glue and 1.25” nails.

Join the shelf boards subsequent. These may even have 3/4” pocket holes on the underside of both facet of each shelf board. Join them to the cabinet using wood glue and 1.25” pocket hole screws. You could line your shelf boards up at anywhere that most nearly fits your storage needs!

Now for the best! This could be a problem panel. I purchased one which was huge enough and cut back it down on my desk seen. Moreover, you should have enough scrap 3/4” plywood to utilize for the best in the event you want to add a trim or edge band to it and get financial financial savings. Join the best by inserting the cabinet the improper manner up on the panel and use 1.25” pocket hole screws through the pocket holes on the cabinet and into the best.

The final word step of the cabinet is attaching the 1/4” hardwood plywood once more. We like to attach ours using a stapler, nonetheless you may additionally use a nailer on this half.

Now to assemble the doorways! Assemble the frames of the doorways first by attaching the smaller 1×3 boards to the longer 1×3 boards using wood glue and 1.25” pocket hole screws through the three/4” pocket holes. I’ve given measurements proper right here, nonetheless it’s always best to measure your cabinet to get a exact match!

Once you paint the faux tin and it’s dry, and paint or stain your door physique, use a scorching glue gun to attach the faux tin panel to the plywood backing. Then, use a stapler or nailer to attach the panel to the once more of the door physique. These faux tin panels are the BOMB. You may discover them HERE on Amazon!